Operate A Device; Using Touchscreen Buttons; Using The Left And Right Button; Using The Direct-Access Buttons - Onkyo Integra TX-DS898 Instruction Manual

Getting Started

4. Operate a Device

You operate devices using three kinds of buttons:
I Touchscreen buttons
I Left and Right button (below the touchscreen)
I Direct-access buttons (to the right of the
touchscreen)

Using touchscreen buttons

Sending commands
By touching the touchscreen buttons you send commands to the
device you have selected. When you send a command, the remote
controller icon shows transmitting signals
device is indicated on the device tab.
Scrolling
Most devices have more than one control panel. You can scroll
through these control panels using
on the left bottom of the screen indicates the panel number and the
total number of panels, for example
By touching and holding a scroll button, you go repeatedly through
all the control panels of a device in a loop.
Operating a device without affecting the active device
You can operate a device while another device is active (for
example, rewinding your VCR while watching TV) via the Device
menu:
1. Open the device menu.
2. Press and hold the Left or Right button (labeled NO
IR).
The remote controller icon turns around
3. Tap the device you want to operate.
The device control panel appears and the remote controller icon
turns to its original position. You can now operate the new selected
device without affecting the active device.
. The name of the active
and . The panel number
.
.

Using the Left and Right button

The Left and Right buttons change function depending on the device
the remote controller is operating. The current function is displayed
on the touchscreen right above the button. The function can be either
an IR (infrared) command that is transmitted, or a jump to a specific
device page.
IR commands
Device pages

Using the direct-access buttons

MUTE, CH and VOL can be operated at any time, even without
turning on the touchscreen.

5. Adjust the Settings

Most of the remote controller's features can be set to your own
needs.
1. Touch and hold the remote controller icon for a few
seconds.
The first setup panel appears. You can see the second and third
setup panel by using the scroll buttons.
2. Tap the button of the setting you want to adjust.
The button becomes black.
3. Use the Left and Right button to adjust the setting.
Note:
Tap the Left and Right buttons are repeating buttons; holding down
one of these buttons will increase or decrease a value repeatedly.
71