Service Guide; Starter Pulley Removal; Air Inlet Net Removal - Zenoah HB2311EZ Workshop Manual

4-1 Starter Pulley Removal

Starter Pulley
Cloth
Puller

4-2 Air Inlet Net Removal

【 【 【 【 Clip Position】 】 】 】
Air Inlet Net
Resin Screw
17

4. Service Guide

Pliers
EB4300/ 6200, EB70 Series, EBZ4800, EBZ51 Series
Box Wrench
Nut (M10)
Starter Pulley
Starter Pulley
EB6200, EB70 Series, EBZ4800, EBZ30/ 51/ 71/ 80 Series
Clip
Screwdriver
HB23 Series, EBZ30 Series
● Insert the stopper (special tool) into the plug hole
(refer to "3 Special Tool") to secure the piston.
● Remove the starter pulley using commercially
available pliers. The pulley must be covered with
cloth to prevent from damage.
CAUTION
Never remove the starter pulley by hitting
with a hammer.
Doing so may damage the pulley.
● Insert the stopper (special tool) into the plug hole
(refer to "3 Special Tool") to secure the piston.
● Remove nut (M10), set a commercially available
puller, then remove the starter pulley.
CAUTION
Never remove the starter pulley by hitting
with a hammer.
Doing so may damage the pulley.
The air inlet net is mounted by four clips.
The removal procedure is shown below.
1. Loosen each clip's resin screw and remove the
whole.
CAUTION
Set the Philips screwdriver against the resin
screw securely. Insufficient or excessive
contact may cause the resin head to break.
2. Insert a screwdriver between free flow net and
frame, then wrench the clip open by twisting the
screwdriver.
CAUTION
Pay attention not to damage the air inlet net
or frame with the screwdriver.