Table of Contents
Advertisement
Appendix C: About SCSI Connection
September 1997
A SCSI terminator is included with the printer. You must
obtain the proper cabling required for your configuration
and system from your printer retailer or distributor.
The two SCSI connectors on the back of the printer are
female submini, 50-pin SCSI II connectors.
Windows Systems
To connect the 8650 Color Printer directly to your computer
(or to daisy-chain the printer through an external SCSI
device), perform the following steps.
1.
Set the SCSI device number using the printer's
display panel.
The printer is set at the factory for SCSI ID 5. If you
need to change the SCSI ID, refer to the Kodak Digital
Science 8650/8650 PS Color Printer User's Guide for
instructions about setting the SCSI device number.
2.
Turn off all equipment before connecting or
disconnecting any equipment from the SCSI bus.
3.
Install the SCSI host adapter board in the computer.
4.
Attach a SCSI cable appropriate to your equipment's
configuration.
If you are connecting the cable directly to the PC, use
a 50-pin submini "D" to a DB 50 cable.
If you are connecting the cable to an external disk
drive, use the cable type appropriate for the drive.
5.
Attach a SCSI terminator.
NOTE: Some equipment is internally terminated.
Refer to the equipment documentation for
details.
6.
Turn on the printer and computer.
7.
Run the Adaptec EZ–SCSI Software install program
to install the software on your system.
C-1
Advertisement
Table of Contents
