Charger - Tomberlin Anvil Operator's Manual

Note: a battery watering gun or bottle is available at many auto parts dealers.
Inspect the wires and terminal connections for corrosion, fraying, or damage. Replace wires
if necessary. Ensure battery wire terminal connector nuts are tightened to 95-105 inch
pounds.
CAUTION
If the battery wires or terminals are damaged or corroded, they should be replaced
or cleaned. Failure to do so may cause them to overheat during operation.
Torque battery hold down straps to 40 in-lbs to insure the batteries are held in place
securely.
After each use, the Anvil should be placed on charge. The batteries should never be
left discharged longer than absolutely necessary.
Battery Charging
WARNING
Batteries emit hydrogen which is an explosive gas. While charging, keep vehicle in
well ventilated areas.
Do not cover the vehicle while charging as an accumulation of hydrogen gas could
result in an explosion.

CHARGER

Onboard Charger
The charger is located behind the front bumper. It begins the charge cycle after connecting
the power plug to the charging receptacle on the side of front bumper. At the same time the
LED indicator located on the passenger side of the dash will flash to show the charger is
charging the battery pack, when fully charged the LED will stop blinking and remain lit until
the charger is disconnected.
Troubleshooting Instructions
If a fault occurs, count the number of red flashes on LED indicator, located on the side of the
Anvil Operator's Manual Page 23