Scheduled Maintenance - Tomberlin Anvil Operator's Manual

Remove all jewelry and loose apparel items.
Use insulated tools while working on any electrical components.
Set the key switch to OFF and the FWD/REV switch to Neutral. Use chocks to secure
the wheels.
Components such as the motor, controller, and resistor may become hot during
operation. To avoid burns, allow these components time to cool before performing
service on the vehicle.
Scheduled Maintenance Procedures
Daily by owner
Weekly inspection
by owner
Monthly inspection
items by owner or
qualified mechanic
Quarterly inspection
items by owner or
qualified mechanic
Semi-annual
inspection items to
be carried out by
qualified mechanic
only
Annual inspection
Anvil Operator's Manual
Accelerator pedal
Battery pack
Brake system
Parking brake
Reverse
Key switch and drive
select
Tires
Warning Decals
Battery pack
Wiring
Entire car
Check all items included in above-mentioned routine checks
Battery pack
Service brake system
Check all of the above routine/weekly inspection items
Rear Axle
Entire car
Check all routine/ weekly/ monthly inspection items
Battery pack
Service brake system
Wires
Switches
Front wheel alignment
Entire car
Check all of the above routine / weekly/ monthly/ quarterly inspection items
Battery pack
Check for normal operation
Check the batteries per page 6 of this manual and fill them to the
proper level as described on page 21 of this manual
Check for normal operation have your dealer service if required
Check for normal operation have your dealer service if required
Check for normal operation have your dealer service if required
Check for normal operation have your dealer service if required
Check tire pressures and for wear, replace as required
If missing or damaged have your dealer replace
Check the batteries per page 6 of this manual
Check if they are secure, and replace if they are damaged
Check if any parts are damaged, loose or missing
Clean the tops of battery pack with soda water
Check Brake fluid level, replenish with DOT 3 rated fluid if
required
Check brake lines and park brake cables for damage, have your
dealer service if required
Check and fill as required with hypoid gear oil
Lubricate as required per the chart following this section
Check the specific gravity level the, electrolyte level and general
state of the battery pack after performing an equalization charge
Inspect the fluid reservoir fill as required (DOT3)
Check the brake shoes and pads for wear, and replace them if
necessary.
Inspect all wiring and connections
Inspect all switches for proper operation
Check and adjust if needed
lubricate entire vehicle as per diagram
Carry out discharge test
Page 18