Tomberlin Anvil Operator's Manual page 11

It is imperative that all operators of the Anvil be familiar with the controls prior to
operation.
To avoid unintentional acceleration and vehicle damage, do not turn the direction
selector switch (forward/reverse) until the vehicle has come to a complete stop.
Always set the parking brake and remove the key when parking or leaving the vehicle
unattended.
Direction Selector Switch
The direction selector switch is located on the steering column. It has three selections, FWD
for Forward, REV for Reverse and a Neutral toggle position located halfway between the
forward and reverse positions.
IMPORTANT NOTE:
This vehicle is equipped with OIC™ (Operator In Charge™) Technology. For Safety,
the vehicle must be placed in the neutral position before the ignition switch is turned
on, it must also be placed in neutral when changing between Economy and High
Performance modes, again for safety the vehicle will only start in economy mode if
the vehicle was left in High Performance mode when shut off it will need to be
switched out of High Performance to Economy and then back to High Performance
while in neutral if that is the initially desired driving mode.
Multifunction Stalk
The Multi-Function Stalk is a multi-feature control. It is located on two sides of the steering
wheel and functions similar to an automobile for turn signaling, headlight (High beam and
low beam), horn control, windshield wiper and defroster button.
Turn Signal
Anvil Operator's Manual Page 10