Compass Calibration Adjustment; Autolamp Delay System; Setting Autolamp - Ford Explorer 1998 Owner's Manual

Controls and features

Compass calibration adjustment

Perform this adjustment in an open
area free from steel structures and
high voltage lines:
• Press and hold the MODE control
until CAL appears in the display
(approximately eight seconds)
and release.
• Drive the vehicle slowly (less
than 5 km/h [3 mph]) in circles
until CAL indicator turns off in
about 2–3 complete circles.
AUTOLAMP DELAY SYSTEM (IF EQUIPPED)
The autolamp sets the headlamps to turn on and off automatically. The
autolamp may be set to:
• turn on the lamps automatically at night
• turn off the lamps automatically during daylight
• keep the lamps on for up to three minutes after the key is turned to
OFF

Setting autolamp

1. Make sure the headlamp control
is in the OFF position. Leaving the
headlamp control on will override
the autolamp.
2. Turn the ignition to the ON
position or start the vehicle.
48
OFF