Advertisement
23(5$7,21
60;
9LVWD
#43.#8VHU*V#0DQXDO
*5$3+;
#
,QSXW#7
,QSXW7
Press
,QSXW7
to select the input connected to
This is the same as entering
,QSXW
,QSXW
Press
,QSXW
as a switcher connected serially to the projector's switcher port. The first digit
represents the switcher number (usually 1-9, or "0" for one of the four inputs on
the projector), the second digit represents the slot number (1-9). For example:
,QSXW
NOTES: 1) Although you don't need to use the input key unless a switcher is
connected to the projector, you can also use
on the projector itself: use
switcher), then
number).
in combination with higher numbers is an invalid entry. 2) See 3.5,
Using Channels and Inputs for a detailed explanation of inputs.
&KDQQHO
&KDQ
to select a channel representing a specific source setup defined and
Press
&KDQ
stored in projector memory. Once you enter a channel number, the display will
automatically update according to the setup parameters defined for that channel.
NOTE: Precise
(from within the Preferences menu) you have chosen for the
example, you can choose to see a scrollable list of channels when you press
or you may prefer to enter a one- or two-digit number channel number. To set up
the
&KDQ
key, see Preferences later in this section.
###
6WDQGE\
6WE\-
Press
6WE\-
and hold for a second or two to blank the display and mute the audio
output while keeping the projector in a warmed-up and ready state. Or quickly
press and release
guarantee the correct toggle (useful if you are unsure of the present status). Note
that all electronics remain ON in standby mode, even though lamp power
reduces to a minimum and the image turns to black. To leave standby press and
hold
6WE\-
again (or use
#
##
0HQX
0HQX
Press
0HQX
to display the main menu. A list of seven numbered options and icons
appears for access to specific functions, such as Channel List or Size / Position.
Press
0HQX
again (or
#
(QWHU
(QWHU
Press
(QWHU
to select a highlighted item, toggle a checkbox (checked vs.
unchecked), finish with a double slidebar, or accept a parameter adjustment and
return to the previous menu or image.
#
([LW
([LW
Press
([LW
to save most parameter adjustments and return to presentation level.
,QSXW
.
when you want to display from a specific source location, such
= display data from switcher 1, slot 2.
as the first digit (representing the projector as the
,
,
, or
as the second digit (the desired input slot
&KDQ
key behavior depends on which Channel Selection option
6WE\-
and follow immediately by
6WE\-
2))
). Or simply press
([LW
) to return to presentation level.
,1387#7
on the projector (S-Video).
,QSXW
to access the four input "slots"
&KDQ
key. For
21
or
2))
if you want to
([LW
.
&KDQ
,
Advertisement
