Advertisement
616
8VLQJ#WKH
.H\SDG
will be green. If it moves to the
restart by first moving the breaker back to the
as usual. If the breaker continues to "trip" (moving to
remain inoperable until the AC problem is corrected. Never use the circuit
2Q22II
breaker as an
switch.
"3-pin and 6-pin. For connecting the optional wired remote
;/5#&211(&7256#0
keypad (3-pin) or optional Two-Way controller (6-pin).
"Emergency access for powering down the projector in the event
+$5'#5(6(7##0
of a system failure. Insert pen point or small screwdriver.
"For hoisting (side handles only) or hand transport of the
,17(*5$/#+$1'/(##0
projector.
67$&.,1*#68332576##0
of three high).
6WDFN#)/225002817#SURMHFWRUV#RQO\1
"For safe hoisting / installation of the projector. Attach with at least
(<(#%2/76#0
20 in. lb. torque.
"For accessing the lamphouse assembly, such as for replacement.
/$03#'225##0
"Louvered area for air intake. Remove to replace 2 air filters.
,17$.(#*5,//#0
The Vista
keypad appears in three locations:
GRAPHX
•
Built-in to the rear of the projector
•
Infrared (IR) Remote for tetherless control
•
Wired Remote (optional) tethered to the front of the projector
While each keypad is identical in layout and provides complete control of the
projector, you may find one keypad more convenient than another for your
specific installation and application.
NOTE: For extra long distances and/or harsh environments, you may prefer to
use an optional remote Vista
For operating details, please see the 2-Way Controller User's Manual included
with the controller.
2II
position, the projector will power off —
2Q
"For secure stacking of projectors on the floor (maximum
:$51,1*
2-way Controller to control the projector.
GRAPHX
9LVWD
23(5$7,21
position, then try powering up
2II
), the projector will
#;3343.HU*V#0DQXDO
*5$3+;
608
Advertisement
