Advertisement
ö
5*%#,QSXW
The RGB input (Input 1) includes BNC type connectors for connection to a
variety of RGB sources. Such sources include VGA, SVGA, XGA, Mac,
PowerMac, DEC, Sun, SGI and others. Vista
types: sync-on-green for data, composite, and separate H & V.
NOTE: Depending on the source, you may need a custom adapter cable that has
BNC connectors at the projector end and different type of connector at the other
(such as a 15-pin "D" connector for computer sources). Contact your dealer.
Connect the sync BNC input(s) first. Then connect the red, green and blue
source outputs to the RED, GREEN, and BLUE inputs on the panel. If the source
uses sync-on-green, only the red, green, and blue connections are required. If the
source provides a composite sync output, connect it to the H/C SYNC input. If
the source provides separate horizontal and vertical sync outputs, connect
horizontal sync to the H/C SYNC input and connect vertical sync to the V SYNC
input. See Figure 2-13.
Connect component video as follows:
NOTES: 1) Vista
When using YUV video, you must specify this signal type within the Image
Settings menu so that the projector can distinguish between this signal and other
RGB sources. See 3.6, Adjusting the Image. 2) For best performance, do not
connect HDTV signals to Input 1 — this type of source requires the HDTV Input
Module (available as an option).
)LJXUH#50451#9LVWD
*5$3+;
Y to "Green"
U (also called B-minus-Y) to "Blue"
V (also called R-minus-Y) to "Red"
10K does not automatically recognize a YUV signal.
GRAPHX
,167$//$7,21#)#6(783
#43.#)URQW#3DQHO
10K supports multiple sync
GRAPHX
9LVWD
#43.#8VHU*V#0DQXDO
*5$3+;
5046
Advertisement
