Advertisement
*XLGH#WR#.H\SDGV
.H\SDG#&RPPDQGV
3RZHU-
#
,QSXW4
,QSXW5
#
,QSXW6
•
the rear of the projector is inaccessible
•
the lighting conditions are unsuitable for proper IR transmission
•
you want to use a separate keypad for each projector in a group
ö
Keep in mind the following guidelines:
4,
Press keys one-at-a-time; there are no simultaneous key presses required.
5,
For any key having an "*" (
two in order to toggle the function with a single key press. For other keys (or
to use a "*" key in conjunction with
similar to a mouse click is sufficient.
6,
Press the "lightbulb key" for approximately one second to temporarily
illuminate the backlight for the keys without sending any other command.
7,
,
,
21
other keys, release and press again to repeat an action.
8,
If you press a key while the projector is busy with another action, such as
during a power-up, the key press may not take effect.
When you turn on the projector it begins operating at presentation level, such as
an image from the most recently used source signal. The projector temporarily
leaves presentation level whenever you use the keypad to work with control
settings, display menus, or on-line help. For example, pressing
displays the main menu — presentation level is no longer active, although the
image continues to be displayed in the background. Press
return to presentation level.
ö
Specific keypad commands are explained below:
3RZHU#2122))
Press and hold for a second or two to turn the projector on or off with a single
key press. Or press
guarantee the correct toggle (useful if you are unsure of the present status).
NOTES: 1) Whenever the projector is turned off, the lamp cooling fans remain
on for about five minutes to cool the lamp sufficiently. Do not unplug the
projector unless the lamp cooling fans have shut off. 2) It is a good idea to
avoid turning a projector back on until it has been off for at least five minutes.
Hot re-strikes of the lamp may reduce lamp life.
##
,QSXW#4
Press
,QSXW4
to select the input connected to
This is the same as entering
,QSXW#5
Press
,QSXW5
to select the input connected to
interface). This is the same as entering
,QSXW#6
Press
,QSXW6
to select the input connected to
video). This is the same as entering
3RZHU-
, for example), hold the key for a second or
21
, and
2))
repeat their "arrow" actions when held down. For
3RZHU-
followed immediately by
,1387#4#
,QSXW
.
,1387#5#
,QSXW
,1387#6#
,QSXW
23(5$7,21
or
2))
), a momentary press
0HQX
after startup
0HQX
again (or
21
or
2))
if you want to
on the projector (data input).
on the projector (an optional
.
on the projector (composite
.
9LVWD
#;3343.HU*V#0DQXDO
*5$3+;
([LW
) to
60:
Advertisement
