Honda RC51 2006 Owner's Manual page 192

05/11/15 12:37:43 31MCF660_192
3. Insert the rear axle shaft from the left
side, through the left swingarm, wheel
hub and rear brake bracket.
4. Install the drive chain by pushing the
rear wheel forward.
5. Install the rear axle nut and tighten the
drive chain adjusting bolts.
Refer to drive chain adjustment (page
143 ).
6. Tighten the rear axle nut to the
specified torque:
94 lbf·ft (127 N·m , 13.0 kgf·m)
Failure to provide adequate disc-to-rear
brake bracket clearance may damage
the brake discs and impair braking
efficiency.
If You Have a Flat Tire
7. After installing the wheel, apply the
brakes several times, then recheck both
discs for caliper holder to disc clearance.
Do not operate the motorcycle without
adequate clearance.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capability.
Taking Care of the Unexpected
183