Resetting Factory Presets - Minelab GPX-4500 Instruction Manual

Resetting Factory Presets

46
1 Turn the detector off.
2 Press and hold the On/ Off switch until the Reset
3 Turn Function Select to the right to select All
4 Turn Setting left or right to restore all
Function Setting
Select
On/Off
Hold for
FP
On/Off
The GPX-4500 is provided with a Factory
Hold for
Preset FP selection of menu settings, suitable
for first-time users.
Until you become more familiar with the
GPX-4500 the detector can simply be
operated with the Factory Presets and the
front panel controls.
To restore all Factory Preset settings:
Defaults menu appears (approx. 5–6 seconds).
Settings (as shown on the diagram).
Factory Presets.
Note: When performing an All Settings reset, the
settings for the four Custom Search Modes are
preserved. This is to prevent your own favourite
mode settings from accidentally being erased
whilst allowing the LCD menu, Deep Mode and
General Mode settings to be quickly restored to
factory settings.
To restore Factory Preset settings for the
current search mode:
Note: If you wish to reset a Custom Search Mode
ensure it is selected in the menu before shutting
down the detector.
1 Turn the detector off.
2 Press and hold the On/ Off switch until the Reset
Defaults menu appears (approx. 5–6 seconds).
Function Setting
Select
3 Turn Function Select to the right to select the
current mode.
Note: If the displayed Search Mode is not the one you
wish to restore you must change the Search Mode on
On/Off
the front panel switch or select the correct Custom
Hold for
FP
Search Mode from the LCD menu.
4 Turn Setting left or right to restore Factory
Preset settings for that mode.
47