Restoring Factory Presets - Minelab GPX5000 Instruction Manual

Restoring Factory Presets

44
The GPX Series are provided with a Factory Preset
selection of menu settings, suitable for first-time users.
Until you become more familiar with your detector, it can
simply be operated using the Factory Presets and the Front
Control Panel.
GPX 5000 Note: When performing an All Settings reset, the
settings for the four Custom Search Modes are preserved.
This is to prevent your own favourite mode settings from
accidentally being erased whilst allowing the LCD menu,
Deep Mode and General Mode settings to be quickly
restored to factory settings.
To restore all Factory Preset settings:
1 Turn the detector off.
2 Press the On/Off switch down and hold until the Reset
Defaults menu appears (approximately. 5–6 seconds).
3 Turn Function Select to the right to select All Settings (as
shown on the diagram).
4 Turn Setting left or right to restore all Factory Presets.
The detector will restore Factory Presets and re-start.
To restore Factory Preset settings for the
current Search Mode:
GPX 5000 Note: If you wish to reset a Custom Search Mode
ensure it is selected in the menu before shutting down
the detector.
1 Turn the detector off.
2 On the Front Control Panel, set the Search Mode switch to
the mode you wish to restore to Factory Presets.
3 Press the On/ Off switch down and hold until the Reset
Defaults menu appears (approximately 5–6 seconds).
4 Turn Function Select to the right to select the Search Mode.
Note: If the displayed Search Mode is not the one you wish
to restore you must change the Search Mode on the Front
Control Panel switch.
5 Turn Setting left or right to restore Factory Preset settings for
the mode selected.
The detector will restore Factory Presets and re-start.
45