Attaching The Universal Connector Cover; Turning On The Radio - Motorola ASTRO APX 7000 Series Quick Reference Card

Attaching the Universal Connector Cover

The universal connector is located on the antenna side of the
radio. It is used to connect accessories to the radio.
Note: To prevent damage to the connector, shield it with the
connector cover when not in use.
op
op
Slot
Hooked End
Bottom
Hooked End
Bottom
Slot
To remove the universal
connector cover, insert a flat-
bladed screwdriver into the area
between the bottom of the cover
and the slot below the connector.
Hold the top of the cover with
your thumb while you pry the
bottom of the cover away from
the radio with the screwdriver.
Insert the hooked end of the
cover into the slot above the
connector. Press downward on
the cover's top to seat it in the
slot.
Rub the ball of your thumb from
the top to the bottom of the cover
while applying pressure towards
the radio. This should flex the
cover and snap it into place.

Turning On the Radio

Rotate the On/Off/
Volume Control
Knob clockwise until
you hear a click.
If the power-up test is
successful, you see
SELF TEST on the
radio's display
these diagrams will be replaced
momentarily, followed
by the home display.
If the power-up test is unsuccessful, you see Error
Note:
XX/YY (XX/YY is an alphanumeric code).
Note: Turn off the radio, check the battery, and turn the radio
back on. If the radio fails the power-up test again,
record the Error XX/YY code and contact your dealer.
On
English
5