HYOSUNG Comet650 Owner's Manual page 74

◉ ◉ TIRE TREAD CONDITION
Tire wear
indicator
Operating the motorcycle with excessively
worn tire will decrease riding stability and
can lead to loss of control.
Inspect storage of tire thread' s depth by
the 『tire wear indicator』 .
Replace the front and rear tires at once
when appear the 『tire wear indicator』 .
CAUTION
The standard tire on
is 120/60-ZR 17 55W for front, and
160/60-ZR 17 69W for rear.
The use of a tire other than standard
may cause trouble.
It is highly recommended to use the
standard tire supplied by Hyosung.
◉ ◉ REAR AXLE NUT
Inspect the rear axle shaft and jointing nut
for loosening.
◉ ◉ TIRE REPLACEMENT
● ●
FRONT TIRE REPLACEMENT
1. Place the motorcycle on the jack or
block.
Tire wear
indicator mark
/ /
�
2. Loosen the four front axle pinch bolt ①
(right and left).
3. Loosen the front axle ②.
4. Carefully position a jack or block under
engine and raise until the front wheel is
slightly off the ground.
Improper jacking may cause damage
to the oil filter.
Do not apply the jack head to the oil
filter when jacking up the motorcycle.
5. Draw out the axle shaft.
6. Slide the front wheel forward.
7. To reinstall the wheel assembly,
reverse the sequence as described.
REAR TIRE REPLACEMENT
● ●
1. Place the motorcycle on the jack or
block.
①
74
�
CAUTION
�