Snowplowing; Installing The Snowplow - Ford 2004 F150 Owner's Manual

Ford 2004 f150
Hide thumbs Also See for 2004 F150:
Table of Contents

Advertisement

Driving
Ford recommends the driveshaft be removed/installed only by a qualified
technician. See your local dealer for driveshaft removal/installation.
Improper removal/installation of the driveshaft can cause
transmission fluid loss, damage to the driveshaft and internal
transmission components.
4WD vehicles electronic shift transfer case:
4x4 vehicles with electronic shift on the fly cannot be towed with any
wheels on the ground.

SNOWPLOWING

Ford recommends that the F–150 used for snow removal include the
Snow Plow Prep Package Option. The option is available for F–150 4x4
Regular Cab and Super Cab (not available or recommended for
SuperCrew), and includes the following upgrades:
• F–150 4x4 (except F–150 SuperCrew)
• 5.4L engine
• Heavy-duty payload package
• Snowplow prep package

Installing the snowplow

Weight limits and guidelines for selecting and installing the snowplow can
be found in the Ford Truck Body Builders Layout Book, Snowplow
section, found at www.fleet.ford.com/truckbbas. A typical installation
affects the following:
• Certification to government safety laws such as occupant protection
and air bag deployment, braking, and lighting. Look for an Alterer's
Label on the vehicle from the snowplow installer certifying that the
installation meets all applicable Federal Motor Vehicle Safety
Standards (FMVSS).
• The Total Accessory Reserve Capacity (TARC) is shown on the lower
right side of the vehicle's Safety Certification Label. This is the weight
of permanently-attached auxiliary equipment, such as snowplow
frame-mounting hardware, that can be added to the vehicle and satisfy
Ford compliance certification to FMVSS. Exceeding this weight may
require the auxiliary equipment installer additional safety certification
responsibility. The Front Accessory Reserve Capacity (FARC) is added
for customer convenience
• Rear ballast weight behind the rear axle may be required to prevent
exceeding the FGAWR, and provide front-to-rear weight balance for
proper braking and steering.
186

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents