Safety Guidelines And Warnings; Chimney Specifi Cations; Wood Insert Specifi Cations; Brick & Cast Installation - Regency Bellerive I200B Owners & Installation Manual

SAFETY GUIDELINES
AND WARNINGS
1) Never use petrol, petrol type lantern fuels,
kerosene, charcoal lighter fuel, or similar
liquids to start or 'freshen up' a fi re in your
heater. Keep all such liquids well away from
the heater while it is in use.
2) Keep the door closed during operation and
maintain all seals in good condition.
3) Do not burn any quantities of paper, garbage,
and never burn fl ammable fl uids such as
petrol, naptha or engine oil in your stove.
4) If you have smoke detectors, prevent smoke
spillage as this may set off a false alarm.
5) Do not overfi re heater. If the chimney con-
nector, fl ue baffl e or the stove top begin to
glow, you are overfi ring. Stop adding fuel and
close the draft control. Overfi ring can cause
extensive damage to your stove including
warpage and premature steel corrosion.
Overfi ring will void your warranty.
6) Do not permit creosote or soot build-up
in the chimney system. Check and clean
chimney at regular intervals. Failure to do
so can result in a serious chimney fi re.
7) Your Regency stove can be very hot. You
may be seriously burned if you touch the
stove while it is operating, keep children,
clothing and furniture away. Warn children
of the burn hazard. For safety reasons a
guard around the fi re is recommended.
8) The stove consumes air while operating,
provide adequate ventilation with an air
duct or open a window while the stove is in
use.
9) Do not use grates or andirons or other
methods for supporting fuel. Burn directly
on the base or bricks where supplied.
10) Open the draft control fully for 10 to 15
seconds prior to slowly opening the door
when refuelling the fi re.
11) Do not connect your unit to any air distribu-
tion duct.
12) Your wood fi re should burn dry, standard
fi rewood only. The use of cut timber, ply-
wood, "mill ends", etc. is not allowed as this
fuel can easily overheat your wood fi re.
Evidence of excessive overheating will void
your warranty. As well, a large portion of
sawmill waste is chemically treated timber,
which is illegal to burn in many areas. Salt
drift wood and chemically treated fi re logs
also must not be burned in your wood fi re.
13) DO NOT OPERATE WITH BROKEN
GLASS.
Regency Bellerive Fireplace Insert
CHIMNEY
SPECIFICATIONS
Before installing, check and clean your chimney
system thoroughly. If in doubt about its condi-
tion, seek professional advice. Your Regency
Insert is designed for installation into a masonry
fi replace.
The appliance, when installed, must be electrical-
ly grounded in accordance with local codes.
WOOD INSERT
SPECIFICATIONS
Your fi replace opening requires the following
minimum sizes:
Height 597mm
Width 699mm
Depth 468mm
BRICK & CAST
INSTALLATION
Insert the rear cast plate fi rst and then the side
plates ensuring the cut out sections lock in fi rmly.
The bricks can then be placed on the base of the
fi rebox between the cast side and rear plates.
Firebrick is included to extend the life of your
stove and radiate heat more evenly.
INSTALLATION
GLASS INSTALLATION
Remove the door from the stove and remove
the glass retainer. Position the glass in the door,
make sure that the glass gasketing will properly
seal your unit, and replace the retainer, it should
rest on the gasket not the glass. Tighten securely,
but do not wrench down on the glass as this
may cause the glass to break.
7