Connecting To The Network And To Power; Connecting A Handset Or Headset - Aastra 9133i Installation Manual

Connecting to the Network and to Power

Inline Power Provided
If your network provides 802.3af compliant
in-line power, the phone is powered
through the network.
1. On the back of your phone, connect the
Ethernet Cable (provided with your
phone) into the network port marked
with l.
2. Plug the other end of the Ethernet Cable
directly into the network jack on the wall.
Inline Power Not Provided
If your network does not provide 802.3af compliant in-line power, you have
to install the PoE inline power supply (optional accessory).
1. On the back of your phone, connect
the Ethernet Cable (provided with
your phone) into the network port
marked with l.
2. On the PoE power supply, plug the
other end of the Ethernet Cable into the
network jack marked as indicated below.
3. On the PoE power supply, connect an
additional Ethernet Cable (provided
with the power supply) into the network
port as indicated below.
4. Plug the other end of the Ethernet Cable
into the network jack on the wall.
5. Plug the PoE power supply into a
power outlet.
Note: You should connect the power supply to a surge protector or power bar. All
Ethernet cables used must be category 5/5e straight-through cables, such as
the cable provided with your phone.

Connecting a Handset or Headset

Handset
Turn the phone over and locate the
handset jack marked j. Insert one end
of handset cord into the jack until it clicks
into place. Then route the handset cord
through the upper groove as shown in the
next illustration. Attach the handset to the
other end of the handset cord.
Model 9133i Installation Guide
To Network
(if Inline power provided)
Ethernet
Cable
To POE
Power Supply
POE
Power Supply
(if Inline power is
not provided)
Ethernet
Cable
To Phone To Network
To Handset
Network Jack
Network Jack
Jack
To Headset
6