Motorola MOTORAZR2 V8 Service Manual page 55

Level 1 and 2 Service Manual
6809515A95-O
3. Protect the light sensor and hall effect sensor on the new K-Flex by covering
them with insulating tape. Do not place the tape on the pink portion of the K-
flex (see Figure 45).
Figure 45. Protecting the K-Flex Sensors
4. Guide the connector through the housing opening during assembly. Use
extreme care when bending the flex.
5. Pre bend the left element to a 90 degree angle.
Figure 46. Bending the K Flex Left Element
6. Insert the K-flex connector and left element into the front housing.
7. Peel away the liner on the right side of the K-flex.
8. Bend the right element to a 90 degree angle.
July 18, 2007
Light sensor
Hall effect sensor
Pre bend element to 90 degree angle
Disassembly
v462522
v462528
55