Motorola MOTORAZR2 V8 Service Manual page 45

Level 1 and 2 Service Manual
6809515A95-O
5. Using the black stick, pry the CLI lens up from the nose of the phone. The black
stick should be inserted into the gap between the CLI lens and the flip outer
at the tertiary porting of the earpiece speaker.
Figure 32. Prying the CLI Lens
6. Once the end of the CLI lens has been lifted sufficiently, slide the black stick
up one edge of the lens to separate the lens from the P-flex. After doing one
side repeat the process on the other side.
7. Pull the CLI lens off in the direction of the nose to the imager.
8. If necessary, use the heat gun to loosen the adhesive between the top portion
of the lens and the P-flex by directing heat between the lens and the P-flex.
Continue to pull on the lens while applying heat. When the CLI lens is removed,
discard the lens, as it should not be reused.
July 18, 2007
Disassembly
v461040
45