Motorola MOTORAZR2 V8 Service Manual page 41

Level 1 and 2 Service Manual
G
6809515A95-O
8. Use a small flat tip screw driver to release the four side snaps. When the snap
releases, press down slightly on the tab to push the keypad away from the front
housing to prevent the snap from re-engaging. Extra caution should be taken
when releasing the snap behind the keypad flex connector - DO NOT DAMAGE
THE FLEX.
9. To replace, place the keypad assembly into the front housing (see Figure 27).
Install the keypad carefully to avoid scratching the housing surfaces.
Figure 27. Placing the Keypad into the Front Housing
10. Ensure that the keypad tabs near the corners and the keypad snaps along the
sides of the keypad assembly are inserted carefully and correctly into the front
housing.
July 18, 2007
Keypad
Disassembly
V461034
41