Load The Material - Roland Stika Plus STX-8 User Manual

Connect the unit to the Computer
Parallel connector
Use the clips on either side to
secure the connector in place.
The cable is available
separately. Be sure to
use the correct cable for
the computer.
Sheet feed knob
Do not place any object
within the area.
3

Load the material

Material of the following composition and thickness can be cut.
- Composition Vinyl chloride sheets
- Thickness Sheet portion :0.1 mm (0.00394") or less, including base paper of 0.3 mm (0.0118) or less
Do not use any of the following materials. The material may come loose during cutting or otherwise fail to be fed properly.
Materials which has
curled upward
Loading the material
Place the material against the pinch rollers.
1
Load the material as shown in the figure, so that it does not
come loose during cutting.
4
Parallel connector
Parallel Cable
Front cover
Screw
Pinch rollers
50 mm
(1-15/16")
Material with a front edge
that is not straight
The AC adapter plugs in here
Use the clips on either side to
secure the connector in place.
AC adapter jack
Subrollers
Do not place any objects within the range of material
movement to the front or rear of the unit.
Material with left and right
edges that are not parallel
Pinch rollers
Make sure the two sides of the material are even
Blade carriage
STANDBY LED
STANDBY key
Blade protector
Material that is longer than
1 m 10 cm (43-1/4")