Table of Contents
Advertisement
• Mouse :
If you plan to use a mouse to control you multiplexer, set
this to On.
• Key lock :
When On, pressing any key or clicking the mouse will
open a screen asking for a password.
• Factory Reset :
Returns all settings to the factory default.
A confirmation screen will ask you if you really want to reset
everything.
• Cam No. Offset :
When set to On, the multiplexer will adjust the
camera numbers based on the Unit Address. Unit 001 will have
Cameras 01 to 04, Unit 002 will have Cameras 05 to 08, etc. When
set to Off, the cameras will be numbered 01 to 04.
•
Mouse setup : If the mouse cannot be worked properly, the user can
change the values as follows.
The ranges which can be changed are Min=minimum, -009~009 and
Max=maximum.
• Master/Slave :
When installed as part of a network, this will
determine if the unit is a master or slave unit.
• Network Type :
The
RS-485 when connected to a network.
• Baud Rate :
When connected to a network, the baud rate can be set
to 1200, 2400, 4800, 9600 or 19200.
• Unit Address :
Networked multiplexers can be assigned addresses
from 001 to 255.
• Protocol :
A is multiplexer protocol.
B1 is dome camera control protocol.
• Exit :
Saves your changes and returns to the Main Menu.
multiplexer
can be set to RS-232, RS-422 or
49
Advertisement
Table of Contents
