Lectrosonics DM1624 Installation Manual page 12

DM Series Installation Guide
5. When the driver installation is complete, the
final page of the Wizard appears. Click
Finish to complete the Lecnet2 USB driver
installation.
Installation additional units (or Lecnet 2 devices)
The Windows XP operating system regards all Lecnet2
devices as separate USB devices because each has a
unique serial number. Because of this, Windows XP will
want to install the USB driver every time it encounters a
Lecnet 2 device whose serial number it does not
recognize. However, if the Lecnet 2 USB driver has
already been installed at least once before on the
computer system, the process is simplified because the
Lecnet 2 installation disk is not required. Use the
following procedure if the LecNet 2 USB driver was
previously installed on the computer system.
1. On the first page of the Wizard, select Install
the software automatically (Recommended)
and click Next> to continue.
12
2. Windows will discover the previously installed
driver and it is likely that a dialog will open
warning you that the driver has not passed
Windows Logo Testing. Click Continue
Anyway.
3. When the driver installation is complete, the
final page of the Wizard appears. Click
Finish. It is now possible to connect to the
Lecnet2 device.