Converting Top Burners - Amana AGS730 Service Manual

Installation
Example Four
1. Remove cap marked "Nat."
2. Reverse cap. "LP" now appears on cap.
3. Reinsert cap. Do not disturb spring beneath the
cap. Verify fiber washer is correctly placed
between cap the regulator body.
Important Note: Some models may not have
washers. If washer is not supplied, none is needed.
Example Five
1. Remove cap with screwdriver slot.
2. Reverse and replace cap. Verify "LPG10" is visible.
Do not disturb spring beneath cap.
Example Six
1. Remove cap with screwdriver slot.
2. Remove black insert marked "NAT" from cap.
(Insert fits tightly in cap.)
3. Reverse insert.
4. Replace in hole. Verify "LP" is visible. Verify that
insert is pressed firmly into shoulder. Do not
disturb spring in regulator body.
5. Replace cap in regulator body and tighten.
Example Seven
1. Remove cap with screwdriver slot.
2. Remove spring and washer. Washer will be at
bottom of spring as illustrated below.
3. Reverse to bring washer to the top.
4. Reinstall spring and washer.
5. Tighten cap.

Converting Top Burners

1. Disconnect electrical supply.
2. Remove grates, caps, burner bodies and main top.
3. Remove screw from each venturi mounting
bracket. Remove venturi assemblies. Orifice
hoods are visible.
4. Turn all four orifice hoods clockwise onto the pins
approximately 1-1/2 to 2 turns. The orifices should
be turned snug onto the pins. Overtightening
orifice hoods can damage the pin or distort the
hole through the center of the pin.
5. Replace main top, burner bodies, caps and grates.
7. Check flame size and shape. Readjust if
necessary.
Pin is located
in the center
15
Burner Orifice
RB231001 Rev. 4