Table of Contents
Advertisement
OPTIONAL REMOTE
CONTROL ACCESSORIES
There are four optional remote controls that can
be purchased separately:
•
wall twitch
•
hand-held ON/OFF remote
• wall thermostat
•
hand-held thermostat remote
See Accessories, pages 36 and 37.
LOCAL CODES
Instal/ and use fireplace with care. Follow all lo-
cal codes, In the absence of local codes, use the
latest edition of 7he National Fuel Gas Code ANSI
Z223.1/NFPA 54*,
*Available from:
American National Standards Institute. Inc.
1430 Broadway
New York. NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA
02269
PRODUCT FEATURES
SAFETY PILOT
This fireplace has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODSMilot is a required feature for vent-free room
fireplaces. The ODS/pilot shuts off the fireplace
it there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor This system in
quires no matches, batteries. or other sources to
light fireplace.
UNPACKING
I • Remove fireplace and hood from carton. Log
is wrapped and inside fireplace. Do not re-
move at this time.
2.
Remove all protective packaging applied to
fireplace for shipment.
3.
Make sure your fireplace includes one hard-
ware packet.
4.
Check fireplace for any shipping damage. If
fireplace is damaged, promptly inform dealer
where you bought fireplace.
ASSEMBLY
A
WARNING:
Always have
branch support and screen in
place before operating fireplace.
This prevents excessive tem-
peratures on fireplace surfaces.
A
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this fireplace
may
result
in property damage
or
personal injury.
ASSEMBLING FIREPLACE
Tools Required:
•
Phillips screwdriver
• 5/16" hex wrench
•
slotted screwdtiver
• scissors
I. Remove two screws dial hold fireplace screen
in place for shinning. These screws are located
near top of screen. Discard screws. Litt fireplace
screen up and pull out to remove. Set screen aside
until installation has been completed.
2.
Cut
NVO
plastic straps to remove the log from
the firebox cavity.
3.
An optional blower is available. See Acces-
sories, pages 36 and 37. Install optional blower
now. Follow installation instructions provided
with blower or (sec page 141.
Shoulder
Burner Support
I '
Locator Tabs
NSc
%
-
Branch
I
Figure 2- Removing Screen
113110-018
www-desatech.com
5
Advertisement
Table of Contents
