Precor C954 Serivce Manual page 64

9. Walk the drive belt onto the drive roller pulley by rotating the drive motor flywheel. Be sure the belt
is fully seated in the grooves of both pulleys and correctly aligned. A drive belt tension gauge
should read 100-120 pounds. The drive belt de-tension after use. A range of 80-90 pounds after
the belt has been installed for a while is acceptable.
Tensioning the Running Belt
10. Move the running belt so that the seam is underneath the treadmill. Place a running belt tension
gauge on each side of the running belt parallel from each other. The gauges have a fixed side and a
movable side. Place the movable side to the middle of its travel and adjust the dial pointer to the
number 3.
Page 1-64
C954, C956 Treadmill
Page 64