Precor C954 Serivce Manual page 41

Diagram 6.2 - Lift Platform Mounting (version 3)
Lift
Platform
Alignment
Hole
9. Slide a 5/32 inch allen wrench or similar slender tool into the alignment hole as shown in
Diagram 6.3. Pull the right hand (lower) lift pin out of the treadmill frame.
Diagram 6.3 - Lift Pin Removal
10. Pull the left hand (upper) lift pin out of the treadmill frame in the same manner as in step 9.
Remove the lift platform from the treadmill.
11. Remove both wheels from the lift platform and re-mount them on the replacement lift
platform.
12. Set the replacement lift platform in its mounting position. Slide the allen wrench into the right
hand lower lift pin alignment hole as shown in Diagram 6.3. Carefully, alignment the lift pin
with its mating bushing in the treadmill frame and tap the lift platform into the frame bushing
with a rubber mallet. The pin should be in as far as possible while still allowing the allen
wrench to be easily removed.
20077-107
C954, C956 Treadmill
Retaining Bolt
Retaining
Bolt
Lift Pin
Allen
Wrench
Lift Pin
Page 41