Recalibrating The System - TracVision M9 User Manual

Recalibrating the System

During installation, the TracVision M9 should have been properly
calibrated. However, if the antenna is moved or if additional
equipment is installed or removed near the antenna, KVH
recommends recalibrating the system. The following sections explain
how to recalibrate the system.
NOTE: This procedure does not apply to large vessels, such as tankers and
large cargo ships.
To perform this procedure, you will need to perform the following:
• Clear the existing calibration score
• Turn on autocalibration
• Recalibrate the system
• Verify the calibration score
Clear the Existing Calibration Score
Use the flowchart in
NOTE: Be sure to turn the system off after completing this procedure. Wait
10 seconds, then turn the system on.
Figure D-1 Clearing the Existing Calibration Score
Tracking <SAT NAME>
Sat A
Install Satellite?
Yes
Select Next until "Operations
Mode?" is displayed.
Operations Mode?
Yes
Figure D-1 to clear the existing calibration score.
Yes
Menu Sat B
Select Next until "Control
Compass?" is displayed.
Next Return
Yes
Next Return Yes
Select Next until "Clear Cal
Score?" is displayed.
Yes
TracVision M9 User's Guide
Appendix D - Recalibration
Get Antenna Status?
Next Return
Control Compass?
Next Return
Set Autocal on/off?
Next Return
Clear Cal Score?
Next Return
69