Removing The Starter Drive; Disassembling The Shift Mechanism - KTM 690 LC4 2007 Repair Manual

2
4
7
8
7
– Turn the freewheel gear
1

Removing the starter drive

– Remove the lock rings
– Pull off both starter drive idler gears; remove the needle bearings.
2
– Take the freewheel gear
– Remove both needle bearings
5
3

Disassembling the shift mechanism

– Push the shift rail
9
– Remove the screw
6
– Press the locking lever
– Loosen the screw and remove the locking lever together with the
bk
1
remove the primary pinion.
with the washers mounted underneath.
2
3
woodruff key .
4
away from the shift lock
6
shift shaft together with the washer mounted underneath.
8
(AH 5 mm) on the shift lock.
9
down to relieve the shift lock
bk
the shift lock.
washer and spring.
in a counterclockwise direction and
off the crankshaft and remove the
.
5
and pull out the
7
4-10
, remove
7