Cleaning The Filters - Sanyo SC-X80 Instruction Manual

CLEANING THE FILTERS

1
Remove the dust compartment.(refer to page 8)
2 Set the dust compartment to the
parallel position. Open the trapdoor,
then push the release button B and
pull out the main filter.
The main filter and prefilter will be
removed at the same time.
Caution: Do not push the release
button B at the upright position.
As this may drop or damage the
main filter and prefilter.
3
Clean the main filter and prefilter with a soft-bristled brush and rinse with cold water.
Allow both items to dry completely.
Cleaning utensil
To maintain optimum suction power, the dust filter fins should be kept clean of dirt.
Clean the filter fins free of dirt with the end of fork as shown.
Reattaching the filters
1
Insert the main filter into the
prefilter as shown.
Main Filter
Close the trapdoor.
3
9
Caution:
Do not use a hard-bristled brush to clean filters.
This may result in damage to the filters.
Do not attempt to dry with a hair dryer or by
placing in a clothes dryer. Hot air may cause the
filters to warp.
2
Prefilter
3
Fork
Hold onto the main filter and insert into
the dust compartment.
Align the ribs of the main filter to match
the shape of the hole in the dust
compartment and press firmly to insert.
Dust Compartment
Ribs
Release
Button B