Sony HDW-F500 Operation Manual page 90

4-4 CUE Menu
To enter the current time code continuously
1
Set item 127.Tele-File IN OUT input in the VTR
SETUP menu to "on."
2
Use the cursor buttons to move the cursor to the
IN/OUT section to be entered.
To move the cursor using the numeric
buttons
With the cursor specifying Time, Mrk, IN, OUT or
the recording starting point section in the TELE
FILE menu display, enter the line number using
the numeric buttons. Then press the [F9]
(CUENUM POINT) button. The cursor will move
to the line specified by the numeric buttons.
3
Press the IN button (to enter IN point data) or OUT
button (to enter OUT point data) while pressing
down the ENTRY button.
The movement of the cursor is automatic (as
described in the table below) and time code is
entered continuously.
Input condition When the IN button is
pressed while
pressing the ENTRY
button
Only IN point IN point data is
data has modified and the
been entered cursor stays on the IN
point data.
Only OUT IN point data is
point data has entered and the
been entered cursor moves to the
next IN point.
Both IN/OUT IN point data is
point data entered or modified
have not and the cursor stays
been entered on the IN point data.
or have been
entered
To display the duration between an IN point
and an OUT point
Use the cursor buttons to move the cursor to the IN/
OUT section and press the IN button and OUT button
at the same time. The duration between two points
appears while the buttons are pressed.
4-48
Chapter 4 Menu Settings
To preroll to an IN/OUT point
Use the cursor buttons to move the cursor to the IN/
OUT section and press the IN button (to preroll to an
IN point) or OUT button (to preroll to an OUT point)
while pressing the PREROLL button. The VTR
prerolls to the point and stops.
For details on setting the preroll time, see "4-2-7 Setting the
Preroll Time" on page 4-18.
Note
If the cursor is not on the IN/OUT section when
pressing the IN/OUT button while pressing the
PREROLL button, the VTR prerolls to the cue point.
When pressing the PREROLL button only, the VTR
prerolls to the cue point regardless of the cursor
position.
Automatic time data changes during IN/OUT
point data entry or modification
The table below shows the automatic changes that
occur in time data when either the IN point or OUT
point is changed.
When IN point data is entered or modified
Status of input data
The time sequence of the
IN/OUT point data is
When the OUT
correct.
button is pressed
The time sequence of the
while pressing the
IN/OUT point data is not
ENTRY button
correct.
OUT point data is
The OUT point has not
entered and the
been input.
cursor moves to the
next IN point.
OUT point data is
When OUT point data is entered or modified
modified and the
Status of the input data IN point
cursor stays on the
OUT point.
The time sequence of the
IN/OUT point data is
OUT point data is
correct.
entered or modified
and the cursor stays
The time sequence of the
on the OUT point
IN/OUT point data is not
data.
correct.
The IN point has not been
input.
IN point OUT point
The data is The data is
changed. unchanged.
The data is The data is
changed. deleted.
The data is The data is
changed. unchanged.
OUT point
The data is The data is
unchanged. changed.
The data is The data is
unchanged. unchanged.
The data is The data is
unchanged. changed.