Furuno RC-1800F Operator's Manual page 203

5-6
2. Select a station. (Station must be registered for the ARQ mode).
Press the [Enter] key. The message "Calling Station" appears.
If the message "Station calling suspended. Check radio and
interconnections. Press any key to escape." appears, check both
radio's power and interconnections between the radio and the
DP-6.
3. When an acknowledge signal is detected, "Connect" appears
in inverse video on the communication status display (see next
page).
Note: If signal conditions are poor, connection may take a
while. If the line could not be connected in one minute, calling
stops and "Calling failed" appears. Try step 2 again one minute
later. Should signal conditions worsen during message
transmission, "Error" appears in inverse video and 30 seconds
later the line is disconnected.
4. Transmit message by one of the following methods;
Send a file from a floppy disk
a) Press function key [F7] (WRU) to receive the answerback
code of the other station. Verify that the code from the sta-
tion called is correct.
b) Press function key [F8] (HR) to transmit your own identity
(answerback code).
c) Press function key [F3] and then the [3] key to display the
Send screen. Select file to send and press the [Enter] key.
Send appears in inverse video while the file is being trans-
mitted.
Filename
<Parent Directory>
00FOX .MES
ASCII .TXT
BEEP .EXE
DPX .AUT
DPX .BAT
DPX .BSC
DPX .CNL
29 Files exist
To select:ENTER
Figure 5-8 Send file screen
Sending volume (percentage of message transmitted, counts
upward as the message is being transmitted), ARQ error count
and ARQ transmission time appear on the display.
Send File
Size Data & Time
96-11-15
95 96-11-15
613 96-11-15
28854 96-11-15
1830 96-11-15
349 96-11-15
28000 96-11-15
1000 96-11-15
247271424 bytes free
To view:SPACE
12:24
08:07
16:15
10:36
10:02
13:54
17:11
10:02
To quit:ESC