Valet Mode; Timer Mode - Viper 791 XV Installation Manual

valet mode

To enter or exit valet mode with the valet/program switch:
1. Turn the ignition key on and then off.
2. At anytime during the next 10 seconds, press and release the Valet® switch. Now the Status
LED will light constantly if you have entered Valet® Mode, and go out if you have exited
Valet® Mode.
To enter or exit valet mode with the transmitter:
To enter or exit Valet® Mode with a transmitter:
1. Open any door.
2. Press on the transmitter.
3. Press .
4. Press again. You have now entered or exited Valet Mode (verify by checking your status LED).

timer mode

This unit can be programmed to start and run the engine every three hours, for a maximum of six cycles. The
engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine.
IMPORTANT! Timer Mode should be used only in open areas. Never start and run the vehicle in an
enclosed space such as a garage or carport.
To enter or exit timer mode with the transmitter:
The same procedure may be used to enter or exit Timer Mode using the remote transmitter:
1. Remote start the vehicle by pressing
2. The lights will flash 4-times.
3. After 1-second the car will start and the timer mode will run for the specified time period.
The system is in Timer Mode. The engine may be allowed to run for its programmed run time, or the transmitter
can be used to shut down the engine. Either way, the remote start system will restart the engine again in three
hours. Timer Mode is exited automatically after the sixth run cycle.
© 2003 Directed Electronics, Inc. Vista, CA
and simultaneously.
51