Viper 791 XV Installation Manual page 36

3.
NOTE: If adding a remote, a button must be taught to the unit in the Channel One or Channel Five
position prior to programming other channels.
CHANNEL NUMBER
1
2
3
4
5
6
7
8
9
10
11
12
*NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
Channels Two, Three and Nine: Channels Two through Nine are used to assign the arm, disarm and panic func-
tions to separate buttons on the remote control. Teaching a button to Channel Two erases all information about
that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed. Similarly, if the
remote is set up to use the separate arm, disarm and panic channels and a button from that remote is entered
into Channel Two, the remote will be erased from memory, and the system will only recognize the button that
was entered into Channel Two.
Channel Twelve: If any transmitter button from a known transmitter is programmed to Channel Twelve, all trans-
mitters will be erased from memory and will revert to the default feature settings. (See Features Menu section of
this guide.) This is useful in cases when one of the customer's transmitters is lost or stolen. This will erase any
lost or stolen transmitters from the system's memory. It can also be used to start from scratch if the transmitter
buttons were programmed incorrectly.
4.
36
Select the receiver channel. Press and release the Valet®/Program switch the number of
times necessary to access the desired channel. Once you have selected a channel, press and
HOLD the Valet®/Program switch once more. The siren will chirp and the LED will blink the
number of times corresponding to the channel that has been accessed.
FUNCTION
Auto Learn Standard Configuration* (default)
Arm only
Disarm only
Silent Mode™/Remote Valet®/Trunk Release
Remote Start
Channel 4
Channel 5
Short Run/Turbo
Timer Mode
Arm/Disarm/Panic
Panic only
Delete all transmitters
Press the transmitter button. While HOLDING the Valet®/Program switch, press the
button from the transmitter that you wish to assign to that channel. The unit will chirp
indicating successful programming. It is not possible to teach a transmitter button to the
system more than once.
WIRE COLOR
RED/WHITE
VIOLET/BLACK
WHITE/BLACK
© 2003 Directed Electronics, Inc. Vista, CA