Electrical Connection; Using Your Refrigerator; Setting The Temperature Control; Defrosting Instructions - AGA marvel Marvel 61RF Operating And Maintenance Instructions Manual

Figure 4
• Do not splash or spray water from a hose on the refrigera-
tor! Doing so may cause an electrical shock, which may
result in severe injury or death.
• This unit should not, under any circumstances, be installed
to an un-grounded electrical supply.

Electrical Connection

A grounded 115 volt, 15 amp dedicated circuit is required.
This product is factory equipped with a power supply cord that
has a three-pronged, grounded plug. It must be plugged into a
mating grounding type receptacle in accordance with the Na-
tional Electrical Code and applicable local codes and ordinances
(see Figure 5). If the circuit does not have a grounding type re-
ceptacle, it is the responsibility and obligation of the customer to
provide the proper power supply. The third ground prong should
not, under any circumstances, be cut or removed.

USING YOUR REFRIGERATOR

Toe kick (Front Grille)
Toe kick screw
Do not use an extension cord with
this appliance.
The unit must be installed according to your local building codes
and ordinances.
NOTE
Ground Fault Circuit Interrupters (GFCI) are prone to nuisance
tripping which will cause the unit to shut down. GFCI's are gener-
ally not used on circuits which power equipment that must run
unattended for long periods of time, unless required to meet
local building codes and ordinances.

Setting the temperature control:

Initially set the cold control midway between the numbers
(between the #3 and #4).After at least 2 hours adjust to the
temperature that suits you. The higher the number you select,
the cooler the temperature. (See figure 6). After loading the
refrigerator allow at least 24 hours for your refrigerator to reach
a new temperature setting.
Cold control
underneath door
in grille
Figure 6

Defrosting instructions:

Never use a scraper or any tool that might scratch or pierce the
cooling plate. Follow these steps whenever 1/4" or more of frost
accumulates:
1) Disconnect the power cord and set the cold control knob
to the "OFF" position.
2) Remove contents.
3) Place pans of hot water on the cooling plate if you wish
to speed up defrosting.
4) Wipe out the interior and replace contents.
5) Connect power cord to outlet.
6) Set temperature control to desired level.
5
Figure 5