Stir Motor; Heater Du (Steam Heater) - Panasonic NN-CS596S BPQ Service Manual

NN-CS596S
4.9.

Stir motor

1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the Inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires from stir motor terminals.
3. Remove 2 screws holding stir motor.
NOTE:
After reinstalling the new turntable motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a screw.

4.10. Heater DU (steam heater)

1. Draw out water tank from escutcheon base.
2. Keep pressing [Steam] pad for more than 2 seconds to
drain the water remaining in the water pipes and tubes into
oven cavity forcibly.
3. Remove tubes from both ends of copper pipe.
4. Remove 1 screw holding air guide B on the base.
5. Remove left and right door key springs from door arm.
NOTE:
Please support door before operation.
6. Turn over the microwave oven and remove all screws
holding base on oven assy & two hinges.
NOTE:
Do not remove two screws holding left and right
hinge on the bottom of cavity front plate.
7. Remove base from oven assy.
8. Disconnect 2 lead wires from heater DU terminals.
9. Remove 1 screw holding thermistor on heater DU.
10. Remove 6 screws holding heater DU & thermal cutout
bracket on the bottom of oven assy.
To install heater DU
NOTE:
1.Please grease enough silicon evenly between the
interface of heater DU and bottom of oven cavity.
(about 0.3mm
16
thickness), this is for good