Install Replacement Cooling Unit - Dometic MANUAL REFRIGERATOR Service Manual

(Bulletin R55/7A c o n t i n u e d )

INSTALL REPLACEMENT COOLING UNIT:

1. Trim the Styrofoam portion of the cooling
unit if
it does
refrigerator.
2. Apply sealing permagum (sealing tape) on
mounting plate (A; FIG. A4).
3. Apply thermal mastic
(B; FIG. A4).
4. T i g h t e n s c r e w s s e c u r e l y t o o b t a i n p r o p e r
c o n t a c t b e t w e e n t h e e v a p o r a t o r c o i l a n d
evaporator flange; otherwise improper cabinet
performance may result.
5. Install the heating element completely back
into the pocket and plug in.
6. Reconnect burner assembly to chimney.
7. Reinstall capillary tube into proper position
(FIG. A3).
B. Category #2
RM100
RM763
RM760
RM1300
RM76
1 RM1301
REMOVAL OF COOLING UNIT:
Remove screw holding clamp for capillary
1.
tube.
P u l l c a p i l l a r y t u b e o u t g e n t l y a n d
place aside (FIG. Bl).
a. RM3600, RM3800 (FIG. B4)
2. Remove heater(s) from boiler case (FIG. Bl).
3. Disconnect burner from chimney (FIG. B2
and B3).
a.
RM2600, RM2800,
(FIG. B3).
not go freely into
on
the evaporator coil
FIG. A4
RM1303
RM2600
RM3600
RM2800
RM3800
RM3600,
RM3800
4. Remove evaporator screws (FIG. B4).
5. Remove screws holding unit from rear (FIG.
Bl).
the
6. Cut tape holding plate (FIG. B1).
7. Apply leverage as shown and pull unit out
(FIG. B
5
INSTALL REPLACEMENT COOLING UNIT:
1. Trim the Styrofoam portion of the cooling
u n i t i f
refrigerator.
D-9-5
).
FIG. 84
it does not go freely
6
WOOD BLOCK
FIG. B3
into the