Standard Wall Plate Mounting - Uniden DG900 DGMax Owner's Manual

) Attach the desktop stand to the base.
Before using your phone,
fully charge the Nickel
Cadmium battery pack for
15-20 hours.
) Set the base on a desk or tabletop
and place the handset into the base as
shown Then, raise the antenna to a
verticle position.

Standard wall plate mounting

M
!
This phone can be mounted on any standard wall plate.
1) Remove the wall mount adapter
from the notches at the top of
the base.
Place the power cord so
that it does not create a
trip hazard or where it
could become chafed and
create a fire or electrical
hazard.
2) Rotate the wall mount adapter
180 degrees and snap it into place
at the bottom of the base.
10
!
Put the AC adapter cord inside the
4)
molded wiring channel, then wrap it
around the strain relief notch. Plug
the AC adapter into a standard
Before you plug the other
240V AC wall outlet.
end of the telephone cord
into the modular jack on
the wall, charge the
battery (refer to "Charging
the Battery Pack," page
16).
5) Plug one end of the short telephone
cord (not supplied) into the
TEL LINE jack on the back of the
base, then plug the other end
into a standard telephone jack.
Line up the mounting slots on the base
with the mounting posts on the wall,
then push in and down until the
phone is firmly seated.
On the base unit, pull the handset
retainer out of the slot and rotate
it clockwise 180 degrees.