Uniden DG900 DGMax Owner's Manual page 6

Selecting a Location
Before choosing a location for your new phone, there are some
important guidelines you should consider:
The location shoud be close to both a phone jack and an AC power
outlet.
Keep the base and handset away from sources of electrical noise
such as motors or fluorescent lighting.
Be sure there is sufficient space to raise the base antenna vertically.
The base can be placed on a desk or tabletop or mounted on a
wall plate.
Your should charge your new phone for 15-20 hours before
completing the installation or using the handset.
Most phone equipment available now uses modular jacks. Phone cords
are fitted with a molded plastic connector which plugs into this type of
jack. If you do not have modular phone jacks, contact your local
telephone company for information about their installation.
Connecting the Telephone Cords
Consider these safety guidelines before connecting the telephone cords
Caution!
Never install telephone wiring during a lightning storm.
l
Never touch uninsulated telephone wires or terminals unless the
l
telephone line has been disconnected.
Use caution when installing or modifying telephone lines.
l
Applying Power to the Base
This phone requires an uninterrupted AC outlet and the included AC
adapter. To relieve strain on the DC plug when the phone is placed on a
desk or table, wrap the power cord around the strain relief notch on the
bottom of the base.
Use only the Uniden AC Adapter supplied with this phone.
AAD 650U Approval Number N14700
Output: 9V 350mA Input: 230~240V AC 50Hz
8
Before choosing a location
for your phone, read the
"Installation Considerations
"Precautions and Important
AC
Safety Instructions" in the
Adapter
beginning of this manual
1) Plug the AC adapter cord into the 9V DC input jack on the back of
the base.
2) Wrap the AC adapter cord around the strain relief notch.
!
Place
hazard or where it could become chafed and create a
fire or electrical hazard.
3) Plug the AC adapter into a standard 240V AC wall outlet.
!
4) Charge the battery (refer to "Charging the Battery Pack," page 16).
5) Plug one end of the telephone cord into the TEL LINE jack on
the back of the base.
6) Plug the other end of the cord into your telephone jack on the wall.
the power
cord so that it does not create a trip
9