Important Notes; Power Source; Activating The Remote Control - Jensen JTA-450 Instruction Manual

REMOTE CONTROL UNIT
1. PLAY/PAUSE BUTTON
2. RECORD BUTTON
3. STOP/CD/USB/SD BUTTON
4. SKIP- BUTTON
5. SKIP+ BUTTON
6. DISPLAY BUTTON
7. PROG BUTTON
8. MODE BUTTON
9. FOLDER UP BUTTON
10. FOLDER DOWN BUTTON
11. DELETE BUTTON
Avoid installing the unit in locations described below:
• Places exposed to direct sunlight or close to heat radiating appliances such as electric
heaters.
• Dusty, humid or moist places.
• Places subject to constant vibration.
This Unit is designed to only operate on normal 120V~ 60Hz household power. Do not
attempt to operate the System using any other power source. You could cause damage to
the unit and void your warranty.
The remote control unit operates on 1 CR2025 Lithium battery (Included).
1. Plug the AC POWER CORD into a 120V AC ~ 60Hz outlet.
2. Turn the System on by sliding the Function Selector (12) to either "TUNER", "USB/SD"
or "PHONO". The LCD backlight will turn on.
Remarks:
If there is a malfunction due to electrostatic discharge (ESD), reset the unit by unplugging
the AC CORD from the outlet, wait 30 seconds and then plug the AC CORD in again to
reset to normal operation.
Remove the plastic insulator tag sticking out of the Battery Compartment of the Remote
Control by pulling on it. Once the tag is removed, the Remote Control will be ready for use.

IMPORTANT NOTES

POWER SOURCE

AC OPERATION

ACTIVATING THE REMOTE CONTROL

5