Page 1
Xpelair Low Energy Wall/Window Fan Range For use with RF Switch GX6 EC3 RF GX6 EC3R RF Installation and Maintenance Instructions Retain for future reference...
Page 7
CLEANING AND MAINTENANCE OF THE APPLIANCE SHALL NOT BE MADE BY CHILDREN. Description A GX6 EC3R RF switch or GX6 EC3 RF switch The Ultra GX6 EC3 RF models have the following (depending on model), available from Xpelair. features: ...
Page 8
the switch location (in the wall or above If installing in a window the ceiling). 2. Lay in the cable from the isolating switch to Obtain a ready cut pane with a correctly located hole, the fan location. 184mm diameter, see Fig. A. 3.
Page 9
4. Switch off the mains electricity supply and GX6 EC3 RF remove fuses. 5. Connect the cable from the isolation switch to The fan is operated by a GX6 EC3 RF switch. the electrical supply wiring. Speed selection between High and Low is via ...
Page 10
4. To clean the impeller, either wipe it with a 42031SK – Inner Grille / Shutter Assembly damp, lint free cloth or wash it in warm soapy 42058SK – GX6 EC3 RF Motor/Duct Assembly water. Do not use strong detergents or 42059SK – GX6 EC3R RF Motor/Duct Assembly chemical cleaners.
Page 11
This page has been left blank for the addition any notes you may wish to make.
Page 12
In the event of a product being returned to Redring Xpelair Group Limited and not found to be faulty, the product would be available for collection from the relevant premises within one month and if not collected it would be disposed of or delivered by Redring Xpelair Group Limited and a delivery charge made.
Need help?
Do you have a question about the GX6 EC3 RF and is the answer not in the manual?
Questions and answers