Connect To The Bv5000 - Blueview BV5000 User Handbook Manual

Connect to the BV5000

After ProScan is installed and the PC configured, it's time to connect to the
system. Open the ProScan Software and click on the connect button, as shown
below.
Note: that if the sonar has just received power, it will take ~30 sec to boot
and be ready for a connection.
Connect
When the connect button is pressed, ProScan should connect automatically to
the sonar and the pan & tilt. If ProScan does not find the sonar or pan & tilt, look
at the troubleshooting section of this manual.
© BlueView Technologies Corp
17
BlueView BV5000 User Handbook