Chapter 3 System Assembly And Testing; Assembling The Hardware - Blueview BV5000 User Handbook Manual

Chapter 3

Assembling the Hardware

1. Attach the sonar into the sonar clamp by loosening the four cap screws,
sliding in the sonar and retightening the four cap screws.
NOTE: The sonar is inserted into the clamp such that its connector is on the same
side as the Pan & Tilt connector.
2. SONAR
CONNECTOR
3. PAN &
TILT
CONNECTOR
NOTE: Use the stickers, side indicators, and connector placement on the
rear end cap of the sonar to determine the up-down orientation of the sonar.
If the sonar is inverted be sure to select the "inverted" option in ProScan's
settings.
© BlueView Technologies Corp
System Assembly and Testing
11
SCREWS FOR
ORIENTATION OF
INSTALLATION
SECTION FOR
INSTRUCTIONS
BlueView BV5000 User Handbook
1. 4X CAP
CLAMP
NOTE
SONAR
REFER TO THE
PAN & TILT
MOUNTING