Assembling Sanding Disc Plate To Motor Shaft; Assembling Lower Sanding Disc Guard; Assembling Sanding Disc Dust Chute - Delta SA180 Instruction Manual

ASSEMBLING SANDING DISC PLATE TO
MOTOR SHAFT
1. Disconnect machine from power
source.
2. Assemble the sanding disc plate (A) Fig. 9, to the
motor shaft with the key (B) in the motor shaft,
engaged with the keyway (C) in the hub of the
sanding disc.
3. Rotate the sanding disc until the set screw (D) Fig. 9,
is in the up position. Insert the 2.5mm wrench (E) Fig.
10, through hole (F) Fig. 10, and tighten sanding disc
set screw (D) Fig. 9.
4. Adjust the disc guard so that the lip (g) Fig. 10,
covers the outer edge of the sanding disc, but
not past the face of the disc, and tighten the two
M4x.07x10mm cheese head screws, one of which is
shown at (H), that attach the disc guard to the base.
ASSEMBLING LOWER SANDING DISC
GUARD
Disconnect machine from power
1.
source.
2. Assemble the lower sanding disc guard (A) to the
disc base using the three M4x.07x10mm cheese
head screws (B), as shown in Fig. 11.
ASSEMBLING SANDING DISC DUST CHUTE
Assemble the sanding disc dust chute (A) to the disc
sander base using the M6x1x15mm cheese head screw
and 6.4mm internal tooth lockwasher (B), as shown in
Fig. 12.
C
G
A
A
11
D
A
Fig. 9
E
F
H
Fig. 10
B
Fig. 11
Fig. 12
B
B