Ignition System - Yamaha WR450F(R) Owner's Service Manual

EC620000

IGNITION SYSTEM

INSPECTION STEPS
Use the following steps for checking the possibility of the malfunctioning engine being attributable to
ignition system failure and for checking the spark plug which will not spark.
*1 Check fuse.
OK
*2 Check battery
OK
Spark gap test
No spark
Check entire ignition
system for connection.
(couplers, leads and
ignition coil)
OK
Check "ENGINE STOP"
button.
OK
Check main switch.
OK
Check ignition coil.
OK
Check AC magneto.
OK
Check neutral switch.
OK
Replace CDI unit.
*1 marked: Refer to "FUSE INSPECTION" section in the CHAPTER 3.
*2 marked: Refer to "BATTERY INSPECTION AND CHARGING" section in the CHAPTER 3.
*3 marked: Only when the ignition checker is used.
NOTE:
Remove the following parts before inspection.
G
1) Seat
2) Fuel tank
Use the following special tools in this inspection.
G
Dynamic spark tester:
YM-34487
Ignition checker:
90890-06754
IGNITION SYSTEM
No good
No good
Spark
No good
No good
No good
No good
Primary coil
No good
Secondary coil
No good
Pick-up coil
No good
Pocket tester:
6 - 3
ELEC
Replace fuse and
check wire harness.
Recharge or replace.
*3 Clean or replace
spark plug.
Repair or replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Repair or replace.
YU-3112-C/90890-03112
– +