Table of Contents
Advertisement
Operation
Before the start, please ensure that amplifier power is off.
Connect sources such as CD player, DVD player or microphone into amplifier's inputs.
Select bridge or stereo function by bridge/stereo switch.
Connect the outputs from the unit to your speaker. The stereo and bridge outputs are labeled
on the panel.
We recommend enabling Limiter.
Set the volumes controls into the "0" position and turn on the power.
Now you can adjust needful volume and tone levels.
Limiter
The limiter is a function that prevents very loud signals from passing through it by limiting the signal
volume temporarily to a normal level. Limiter prevents damage to the speakers or the unit itself.
The limiters primary function is to help prevent one time very loud signals such as a dropping of a
microphone or short loud parts of the music signals. Turning the limiter on may helps protect from sort
overloud, but it is not intended for total dynamics control.
Installation
Troubleshooting
Check power adaptor and power cable.
If power supply is good and LED of the
No power
supply is lighting check the amplifier. If
not, please change power supply.
Check speaker's line maybe line is
No sound
overloud and simultaneously check
maybe speakers is in short circuit.
Check the connections of the devices,
Very high
and check signal level maybe level of the
noise
input signal is too big. Make sure that
amplifier is not overloading.
level
Advertisement
Table of Contents
