AMC 2A Series User Manual
  1. Manuals
  2. Brands
  3. AMC Manuals
  4. Amplifier
  5. 2A Series
  6. User manual

AMC 2A Series User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2A Series and is the answer not in the manual?

Questions and answers

Related Manuals for AMC 2A Series

Summary of Contents for AMC 2A Series

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: 1. Read all instructions before using the product. 2. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool.etc).

  • Page 3: Table Of Contents

    CONTENTS: Before you start What's in the box Features Hints on installation Controls and connections Front panel Rear panel Connections examples Specifications Specifications...

  • Page 4: What's In The Box

    RACK MOUNTING The 2A Series amplifiers are designed for standard 19" rack mounting as well as stand alone. Use 4 screws and washers for mounting to the front rack rails. It is also a good idea to support the amps in the rear, especially for mobile use where the amps will be subjected to strong vibrations.

  • Page 5: Front Panel

    Front Panel 1. PROTECT LED INDICATORS 6. POWER SWITCH These LEDs illuminate if the power amplifiers To turn the unit ON or OFF, press this button. output connection is shorted or the load Before turning on the amplifier, check all impedance is too low.

  • Page 6: Rear Panel

    Rear Panel 1. INPUT CONNECTORS active. minimum loudspeakers Connect your input signal to these balanced impedance should be no less then 4Ω. Please phoenix or XLR connectors. Link connector note that prolonged outputs overdriven can allows to have direct output from input be reason of main fuse blowing.

  • Page 7: Connections Examples

    Connections examples STEREO SYSTEM (stereo mode) MONO SYSTEM (parallel mode)
  • Page 8 MONO SYSTEM (Bridge mode) Block diagram...

  • Page 9: Specifications

    Specifications Power specifications 2A400 2A600 Rated output power (8 Ω) (Stereo mode) 2x400W 2x600W Rated output power (4 Ω) (Stereo mode) 2x700W 2x1050W Rated output power (8 Ω) (Bridge mode) 1250W 1750W Rated output power (4 Ω) (Bridge mode) 1700W 2300W Input Sensitivity 0.775 V (0 dBu)/ 1.0 V (2.2dBu)/ 1.44 V (5.3 dBu)
  • Page 10 AMC is a registered trademark of AMC Baltic www.amcpro.eu...

Table of Contents