Installation; Electrical Connection - Baumatic TITAN5 Instruction Manual

o Run the water dispenser for 3 – 5 minutes, at 1 minute intervals,
to flush out the water tank.
o Reset the water filter change neon (as described on page 19).
o IMPORTANT: After installing a new water filter, discard all
ice that is produced in the 24 hour period following the
replacement.
o The fridge water dispenser and the ice cube maker MUST
NOT be used without the water filter.
o Replacement water filters are available from the Baumatic
Spares Department.

Installation

IMPORTANT: We recommend that the appliance is installed by a
qualified technician.
IMPORTANT: Before installation and usage read
all the instructions and make sure that the
voltage (V) and the frequency (Hz) indicated on
the rating plate are exactly the same as the
voltage and frequency in your home.
The manufacturer declines all responsibility in the event of the installer
failing to observe all the accident prevention regulations in force,
which are necessary for normal use and the regular operation of the
electric system.

Electrical connection

YOUR FRIDGE FREEZER IS INTENDED FOR FITTED
AND PERMANENT INSTALLATION.
We recommend that the appliance is connected by a qualified
electrician, who is a member of the N.I.C.E.I.C. and who will comply
with the I.E.E. and local regulations.
o Your refrigerator comes supplied with a 13 amp plug fitted. If in
future you need to change the fuse in this plug, then a 13 amp
ASTA approved (BS 1362) fuse must be used.
36